Cleaning and Primers: CRL Urethanes are supported by a one-step primer and aerosol cleaner formulated for use in all aspects of glass bonding, including the glass frit, pinchweld, and EPDM/PVC moldings.
1. After removing all of the old urethane to within 1/16" (1.5 mm) of the pinchweld, prepare the pinchweld following the procedures outlined in the CRL Technicians Training Manual. Prime these areas with
1214006 One Step Primer.
2. Clean the inside of the windshield with a lint-free towel
1550 and
PWR22 Automotive Glass Cleaner.
3. Apply the same
1214006 One Step Primer to the frit area with a lint-free towel and allow to dry for a minimum of 10 minutes, but no more than 8 hours before installing the adhesive. This procedure must be performed above 40°F (4°C).
NOTE: One Step Primer must be used prior to any adhesive application to prevent glass displacement. Failure to do so may result in personal injury or property damage.
4. Apply
1214006 One Step Primer to encapsulated moldings if they are part of the bonding area.
Packaged in metal cartridges with 4-1/2" (114 mm) long screw-on Cone Nozzles included in every case. 12 cartridges per case.